Questions & Answers for: change key lock 1997 old

...change a new key. I need diagram how to remove the old one. You should be able to give you vin number to the dealer. they can cut you a new key. As for removing the lock... you need to turn the ...

...change ignition without a key and how do i access the steering colum to change it diconnect battery and wait 30 minutes, then remove steering whell and then remove clip holding lock plate, remove ...

...key won't turn sterring colum. wiggle sterring column back and forth while turning key. You can also take shifter and wiggle up past park depending on which way its locked grab hold of the wheel and ...

...key lock cylinder into their proper place to move the cylinder into the starting position. Or your steering colum is locked and the wheel is moving freely as if it were not. So your solution would be ...

...will start and run but will not turn. rock the steering wheel with the key on also the lock plate pin under the wheel inside of the column could have a groove wore in it and locking into to lock ...

...change to key lock ignition. I have the steering wheel off and the turn signal arm off. I have the igintion cylinder out of the steering colum. How do I get the old iginition key lock out of the ...

...1997 328i steering colum with another from an automatic trans car that was a year or so newer--(this one is a manual)--everything fit fine until we noticed the ignition switch on the original colum ...

...lock cylinder removal xj6 1997 To remove the ING barrel put the key in turn to position one.on the side of the colum round the barrel there is a hole you need to press the button down that is in this ...

...the box that goes to the ignition,you need to have the key fob and key also,unlock and lock the doors with the key fob a couple times then insert the key and start it,if it doesnt work,call a ...

...key thin the one on the colum? Your best bet is to remove the lock out of the old one and put it in the new one. First look at the keys, If they have a small square on the back end, this is where the ...