...ignition coil but no change how do i fix this? there is a small condensor on the distributor. It looks about 2" long about 1" wide with one wire and an earthing screw. Replace that, it should solve ...
...1988 Ford Bronco II that will run for a few minutes then shuts down. I let the engine cool and I can restart it. I get engine codes # 18 and 21. check or replace ignition module and coil if injected ...
...switch , but it was not tripped. in tank fuel pump is getting old sounds like an ignition module. i had a simular problem where i would be driving and my bronco would just shut off and i would wait ...
...1988 Ford Bronco don't work? Not necessarily. By the year of the vehicle it could be switches or possibly motors. Best bet would be switches. Check to see if you have 12 volts before and after the ...
1988 ford bronco two running rough , no power, sluggish, barely passed smog. 2.9 litre, code 66 low voltage check your ignition system.
...So basically you will need to inspect the TFI or replace and also check under the steering column there is the ignition switch (electrical switch), if that fails then you will get 6 volts to ...
...diagrahm for 1986 ford bronco II Try this site it has the diagram for 83-88 bronco ...
Question about 1988 Bronco II
...1988 ford bronco II cranks up and runs great but when i shut it off it will not crank back up. it takes like 20-30 mins before it will crank up again. there is something getting hot and keeping it ...
Question about 1988 Bronco II
...switch stil no power Check the wires going to the fuel pump relay for a ground with the ignition on. The reay requires a ground sent from the ecu to activate the relay and sent power to the fuel
finding a ignition lock housing and my 1988 ford bronco ll For my 1988 ford bronco ll Check on www.rockauto.com
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions