Questions & Answers for: change fuel level sensor 2005

...but immediately within 2 seconds it shuts off Chek for Fuel Filter and Pump.... Vacumm lost. and Idle sensor for contact lost during engine run Possibility gas line interuption due to Fuel Pompe ...

Ad

Question about 2005 Malibu

1 Answer

I need help to know what it is. it is most likely a faulty fuel level sender in the tank, and the check engine light is on because of a fuel level sensor code. the tank will need to come out to change

Ad

Question about 2005 Altima

2 Answers

...change the fuel pump? Also where are the crankshaft sensor and the fuel pump relay located. Thank you for your help. yes you have to drop tank to replace fuel pump and filter as it is one unit pretty ...

Question about 2005 SSR

1 Answer

...change & reset % oil use. All the problems started. Changed Thermostat, Water Pump, both relays, Radiator Cap, System fushed 2 times using Penzoil Super flush. When Coolant was Drained it was ...

Question about 2005 Freestyle

1 Answer

fuel level sensor How do I replace the fuel level sensor? It is located on the fuel pump module which is located in the fuel tank. The fuel tank will need to be removed from the vehicle in order to ...

Question about 2005 Malibu

1 Answer

...Fuel level sensor circuit harness is open or shorted - Fuel level sensor circuit poor electrical connection - Faulty fuel level sensor in fuel tank (most common cause)P0463 DescriptionThe fuel level ...

Question about 2005 Malibu

1 Answer

...to empty This problemis always caused by a defective fuel level sensor. The level sensor islocated of course in the gas tank. To change the level sensor you must remove the gas tank from the

Question about 2005 Grand Prix

1 Answer

...change the fuel level sensor on my 2005 grand prix? My light is on and received code P0464. As far as I know ,for the last 65 years, the fuel levelgauge & now fuel sensor is in the fuel tankHave ...

2005 ssr was equipped with an LS2 6.0l v8. On those engines (as well as many other SBC) the Crankshaft position sensor or CKP is mounted on the passengers side of the engine block, at the very back of

...change if i got a po463 high input. code p 0463 refers to fuel tank level sensor --high input ===causes --wiring short to positive --fuel tank level sensor ---ECM remove a wire from each at a time to ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...