...Camshaft position sensor circuit range performance Blank 1. I have changed the cam sensor and the VVT sensor and the light still comes back. Car runs excellent.Light comes on a few minutes after ...
Question about 2005 Yaris 1.3
...3. Camshaft position sensor 4. Ignition system 5. Fuel pump control circuit 6. ECM 7. Voltage output circuit Engine cranks normally but difficult to start 1. Fuel pump control circuit 2. ...
Question about 2001 Yaris
...Camshaft Position (CMP) Sensor A (G40), Bank 1 - Circuit Malfunction Possible Cause: Malfunction Indicator Lamp (MIL) active. Wiring from/to Camshaft Position Sensor (CMP) faulty. Camshaft position ...
...sensor 3. Camshaft position sensor 4. Ignition system 5. Fuel pump control circuit 6. ECM 7. VC output circuit 8. Engine ground (Brown bunch of wires attached to the cylinder head as sensors
...Camshaft Position Sensor B Circuit Malfunction Solution: - Delete codes - Check the connector and wires attached to the cam shaft position sensor. - Cam shaft position sensor defective. (Replace with ...
Question about 1996 Tacoma
...camshaft position sensor on a 1996 toyota tacoma 2.7 located. Camshaft Position Sensor 1996 Toyota Truck Tacoma 2WD 2.4L EFI DOHC 4cyl The Camshaft Position Sensor is located: Under hood, passenger ...
...Camshaft Position sensor - Faulty Camshaft Position Solenoid Valve - Engine mechanical condition - Valve timing off - Intake Camshaft Position sensor harness is open or shorted - Intake Camshaft ...
Question about 2001 Corolla
Changed camshaft position sensor on 2008 Toyota Yaris ,circuit a check engine still coming on Are you getting the same code?If so,sometimes the crank sensor can affect a cam sensor code.
Question about 2001 Corolla
...change ECM,crankshaft sensor,camshaft sensor and electrical circuit but not starting the key have no immmobilizer There is no spark and injector pules i well change ECM, crankshaft sensor ,camshaft ...
Question about 2007 Yaris
0 engine 2007 model. Question edited for a lot more clarity. Question moved to model category. Could the wobbling pulley have destroyed the crankshaft position sensor? You need a good auto electrician
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions