Questions & Answers for: chainsaw sprocket size

size of file should I be using? I think you are asking about the chain installed on your saw. It can be different depending on the sprocket and bar installed. I'd visit my local saw shop. They can use

sprocket The following is copied from the Oregon FAQ "What is pitch". Chain pitch is the distance between any three consecutive rivets divided by two. Pitch defines the size of the chain. OREGON®

bar groove might not be the right size. You might also check out the sprocket to see if it is bent or damaged. I hope I have helped even a little bit. All the best and good luck. Any questions welcome

...chainsaw for cleaning today, the end of my crankshaft holding the sprocket for the clutch on just fell off. The end of the shaft just sheared off very neatly, so I looked up all the instructions on ...

why will my ps7910 not rev up Check the Setting marked (L) for low idle on the carburetor. Turn counter clock wise & see if that helps. If not then turn back to correct position. Don't touch (H)! ...

...size chain your go kart uses if you don't have the old chain then measure your front and back sprocket and count the number of teeth. a shop will be able to find the right chain with these ...

...chainsaw a fix maybe hard to do but here goes 1. be sure chain is right size for bar as in bar groove for chain right size, sprocket gear right size and chain right length for bar. 2. be sure bar is ...

chainsaw sprocket. Have you replaced the chain just recently? I'm only asking because even though it may be the right length, there are chains that have different sized drive links. Very seldom do the

The size of the left handed bolt for removing the chain drive sprocket. Depends on the make and model which you haven't stated. But I could make a guess if you'd like. Anywhere from 13mm to 19mm

Chainsaw chain rotates when starter pulley is pulled, why? I replaced 16 inch bar to 20 for husqvarna 235. The seller reassured me that it won't wreck the machine. After a light use, it stopped ...