Question about 16 In 4.5 Hp Electric Chainsaw With Carrying Case MCC4516FK
...quits after 10 I have a Stihl Pro 260 Chainsaw. It starts off running strong, but after about 10-15 minutes. It gets hot and quits. It then doesn't want to run at all. I can feel quite a lot of heat ...
Question about Pro 42CC 2 Cycle Chainsaw, 18"
...quits using a new spark plug. Why do you suspect the fuel system? Does the engine quit suddenly or sputter to a stop? Does the engine have to get hot before it will quit? Sudden stop is usually ...
Question about Pro 42CC 2 Cycle Chainsaw, 18"
...chainsaw once it has run for about 8 mins hard sawing there is a ping sound and then the engine quits. After letting it set for about 15 mins I am able to restart the saw and begin sawing again. But ...
...chainsaw. It starts fine, but dies midway thru a cut. Not sure what the problem is? Thank you Immediately after saw quits, while everything is still hot. Sometimes ignition modules quit working when ...
...chainsaw dies out after about 10 cuts (5 min). I have to wait an hour or so before it will start again? Is it just overheating? (I use the recommending fuel/oil mix and proper bar chain oil). Does it ...
chainsaw starts and runs fine for approx 30 min of initial use. After that it will not idel. Upon giving it throttle it just cuts out and quits instantly. To restart it has to have full choke or won't
Question about Pro 42CC 2 Cycle Chainsaw, 18"
...quits: Ignition Coil Test by SmallEng.com http://www.youtube.com/watch?v=L7WNBDRG4C4 You may need to use a jumper wire between the threaded part of the plug and the cooling fins. You do not have to ...
...hot , difficulty in reverse mode. sounds like your mix may be too lean on oil ? if so could have damaged saw , remove muffler check piston could be running lean mixture ie carb setting too lean or a ...
Question about Pro 42CC 2 Cycle Chainsaw, 18"
hot .then it quits and wont start again till it cools off. hi could be breather playing up , but most likley ignition coil breaking down / going open circuit when hot try another ignition coil , reset
...running hot and then quit. Could not intially pull cord but that loosened up after a few attempts. Checked spark which was ok. Put thumb over spark plug hole and has compression. However, thumb was ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions