Question about Pro 42CC 2 Cycle Chainsaw, 18"
...it and it seized, piston is now seized Did you mix the proper amount of oil with the gasoline? Are you sure the piston is seized and it isn't just that the chain is too tight for the sprocket to
...seized piston; spark plug is rusty orange as well as 50% top of piston! Water in fuel? It Could BeTwo Things.One is condensation from sitting for along time.Two is if it was setting outside in thr ...
Question about Pro 42CC 2 Cycle Chainsaw, 18"
...chainsaw. The dealer says I ran it with oil in the gas and I did not. What can cause the same effects of the appearrance that there is no oil in the gas. cylinders that seize around the exhaust port ...
chainsaw is not seized up because it has compression when I pull the starting cord. If you have fuel to the plug and a spark at the plug it is going to fire, unless it has sheared the flywheel key and
piston has seized, remove the muffler and check out the condition of the piston skirt through the open exhaust port, any signs of scuffing and the piston has seized, it will then need to come apart to
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
...piston in my 288 and it seized I put a new barrel and piston on my husky 288xp it ran for 5 minutes and it seized i run a fuel mx of 20 to 1 Have you used a geunine OEM cylinder and piston. Cheeper ...
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
how to tap piston with wooden punch to loosen? if your piston is seized then get a new piston and cylinder or a new machine
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
...chainsaw acts like its seized then after a few minutes turns over fine and starts.whats wrong? saw was purchased in 2004 It has run too lean for a while and the piston and rings are damaged. The ...
...chainsaw. I over heated/seized my saw and need to repair, how do I un-siese it and re-ring it? basically you need to strip it down, remove the cylinder off the piston, then remove the piston itself. ...
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
...after it cools down it the piston will shrink and the chainsaw will run again. Too many times and the piston will score the cylinder causing damage and space between the cylinder wall and the
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions