...is at 50 CPS too. I wouldn't! It will run at half power, it may overheat, probably not safe. How much value do you place on your life? A new chainsaw (built for 110VAC) is pretty cheap insurance. ...
it is overheating Generally chainsaws overheat when the chain is not sharp enough or the chain oil is not getting to the chain. To check the chain oil run the saw with the end pointed at a white sheet
I need a manual for a new Poulan 3.5 electric chainsaw, or, failing that, I need instructions on what kind of oil to use on it, and whether I need separate oil for the chain. You shouldn't need ...
...overheat and cut out after 1/2 hr-2hrs? Let it sit and cool and fires right up again Chainsaws will do that, as you are asking a small but tough little engine to do a lot of work. Consider using that ...
Question about Service Manual for 051AV Chainsaw with Parts List
runs for 4 minutes then overheats and stops Check cooling fins on cylinder head are clean, clean filter, clean exhaust, all these things help disperse heat from the engine. Make sure fuel/oil mixture ...
Question about Service Manual for 051AV Chainsaw with Parts List
My model 10550 overheats on large wood. I have changed the oil mix but it did't help does it overheat then cut out if so it will be oil mixture also is it a manual pump or not chain needs to ...
Question about 021 023 025 Ms210 Ms230 Ms250 Chainsaw Handle Bar
Stihl MS250 Chain saw overheats. I have had two MS250 saws overheat and be ruined. I have always been careful with the fuel mixture. I have kept the saws clean. The saws were not old. In fact, I had ...
Question about 021 023 025 Ms210 Ms230 Ms250 Chainsaw Handle Bar
Stihl MS250 overheats and burns out engine. the carb fuel augments mite be set to lean or gas oil mixture not mixed rite
Question about 021 023 025 Ms210 Ms230 Ms250 Chainsaw Handle Bar
...chainsaw quit oiling ? Strip and clean the saw wash oil tank with some petrol LET it dry if you have run the saw with no oil or no oil pumping the pump can overheat that can be the end of it a work ...
...chainsaw will not start it just stopped running. is there a fuse or reset button The switch has failed or you broke contact in the plug. Replace the saw and use it only under light load on dried wood ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions