Questions & Answers for: chainsaw die give gas

...chainsaw will start just fine, but when I give it the gas it dies. Please give me some advise as to what it might be. The chainsaw only been used 4 time and for very short times at that. adjust the ...

...chainsaw runs fine until gas is pressed. When gas is pressed all the way, it dies instead of reving up to full throttle. Carb needs teardown and cleaning. May be a stuck float or clogged jet. ...

saw was runing and died now it want crank My saw also died while running and is now just giving off a gust of air on the hits it would usually crank. Is yours doing this also?

...chainsaw will start on choke but dies when you give it gas You need to strip and clean out the carb. The main fuel passages and jets are blocked or stuck. A new gasket set would probably also not be ...

chainsaw wont throttle up dies out;cleaned out carb. relaced fuel lines . give it gas wont throttle up.adjusted high and low speed screws no luck. replaced fuel lines and filters.sounds like its ...

...give it gas. The saw is only about 1 year old also I think the bar oil is leaking out when I store it. It dies because it's flooding as you increase the amount of flow, a small carb adjustment is ...

...chainsaw dies when I give it gas and I think the bar and chain oil is leaking out during storage. leaking chain and bar oil during storage and dies when I give it gas try and run it with the muffler ...

every time i give it gas it dies sounds like air is getting into the fuel line ~~ check the intake fuel hose for cracks.chris...

My Poulan 260 LE Pro Chainsaw starts but dies when I give it gas inspect the carburetor for stiff diaphragms

......