chain tension using the screw that is located either between or below the two nuts that hold the sprocket/bar/chain cover. Loosen the nuts and turn the screw clockwise to tighten, counter-clockwise to
...tension correct. the adjuster screw is on the other side of the chain bar to the 2 nuts you just loosened. turn it clockwise until free play is removed but but no more. tighten nuts back up. job
Question about Chain Saw Handle Models 50 51 55 154 254
will not cut blade stops with very little pressure when cutting. chain is engaged correctly on sprocket Check the chain is travelling in the right direction, the teeth are sharp and there isn't ...
...screw at the back of the bar and back it off.The chain should have about 1/8 slack when pulled from the bottom of the bar.A tight chain will heat the bar and turn it blue close to the chain guide.A ...
Question about "Chain Saw - 16" Bar, 3 Hp
...oiling properly on my husqvarna 51? The self oiling feature on the chain on my husqvarna chainsaw model 51 does not seem to be working. What can I do to correct this problem? Put oil in the
Question about Chain Saw 20" Bar
...I'm looking to buy a new screw to replace the chain tension adjustment screw that I somehow lost. Does anyone know what size screw I need for that purpose? i think its 6.0x1.0 ...
Question about Chain Saw Models 51, 55
the Husqvarna chain saw models 51 and 55 does not starts. Is this about two different chainsaws? You will need two different posts giving the particulars about each saw.
Question about Chain Saw Models 51, 55
...Husqvarna chain saw model 51 have replaced bar and chain and am still cutting at an angle asked before and am know thinking the sprocket might be the problem should I replace? I asked earlier have ...
Question about Chain Saw 20" Bar
chain tensioner screw keeps breaking on husqvarna 455 rancher I have replaced the chain tensioner screw a number of times. Any ideas? The tensioner should only move the bar when the retaining nut/nuts
Husqvarna 51 file size Several bar and chain combinations fit the 51 model saw. If your saw runs an H46 / H80 or H81 style chain you will need a 7/32" (5.5 mm) If you are running a H21 style chain you
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions