POWER TOOLS CHAIN SAWS THE SAW STARTS AND IDLES BUT WONT THRODLE UP WE REBULT THE CARBERATER AND STILL WONT THRODLE UP HOMELITE 420 Maybe it has a bad reed valve, check it.
Question about Forest & Garden No.967012396 345 16" Gas Chain Saw
...low. Your high adjustment idle screw needs to be adjusted. Firefishin is right I have a Stihl 028 Woodboss chain saw and of had the same problem until i touch the low idle screw it sloved my
chain from rotating. High speed (with throttle wide open). Set needle 1-1/4 turns open, checking for smooth acceleration by opening the throttle wide for 3 seconds. If the saw stumbles, turn needle to
Saw started after 2 pulls but wont idle - no matter what i do with the low speed adj.or throttle adj. It revs up on high speed no problem-but cant idle....any ideas? tks... set you carb adjustments at
Question about 30.1CC Chainsaw With a 14 In.bar and Chain
...saw wont idle. I have tried adjusting the low speed mixture screw, changed the fuel filter and spark plug, air filter is clean, fresh fuel, and nothing seems to help. I have disassembled and ...
...chain wont stop when i let off gas Turn the T screw CCW until the chain stops turning at idle but not so far that the engine stalls when going to idle. If the screw has no effect on idle speed, ...
...Chain Saw - Describe your "Chain Saw - 16" Bar, 3 Hp Problem my 440e wont run at full throttle. starts and runs at idle fine A couple of things too check here, remove the air filter and ...
chain saw wont throttle down to idle saw starts good just wont throttle down to idle whats going on?? check the choke linkage it props the throttle open Hi. I have same problem.. Thanks for your
Chain Saw Stihl 290 Farmboss wont idle well can keep the saw running,but wont idle on its own Check to see if the air filter is clean. If it is, increase the idle speed adjustment screw on the ...
Question about "Chain Saw - 16" Bar, 3 Hp
...keeps running trigger wont release and stop the chain chain saw is the guess it has a centrifugal clutch so that means that the idle speed is too high or there is a clutch failure jamming on the ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions