...chain saw carb tune I rebuilt the walbro carb on my chain saw. It starts and runs fine but tends to die at high rpm under load. You have to feather it to keep it running. Once it dies it will not ...
Question about Husqvarna Garden
...chain saw dies after 10 to 20 minutes. Saw never worked right. Found that by opening the gas cap for a second when it sounded like stalling the saw would run for another 10 to 20 minutes. I can keep ...
Question about Forest & Garden No.967012396 345 16" Gas Chain Saw
...chain saw will not run After many 10-15 pulls it may start. But after I get it to idle I increase the rpms and it will die. Sounds like it floods out. I have drained the gas checked the diaphram. ...
Question about Wild Thing 2375 18" Gas Chain Saw 2.5 Cuin
...chain saw after carb rebuild. I rebuilt the walbro carb on my chain saw. It starts and runs fine but tends to die at high rpm under load. You have to feather it to keep it running. (move the throttle ...
Question about Wild Thing 2375 18" Gas Chain Saw 2.5 Cuin
Craftsman 358.360280 42cc seems to be starving for gas The saw is 5 years old. When cranked it would seem to be starving for gas and you had to keep it reved up to keep it running and if you let it ...
...chain saw, Mcculloch, pretty new. Starts then dies in few seconds. Gas, bar oil OK. Guessing it's loading up....? Remove and inspect the spark plug for fouling. Replace if needed or if you have never ...
Question about Wild Thing 2375 18" Gas Chain Saw 2.5 Cuin
...chain saw will rev fully when idle but Husqvana 65 chain saw will rev fully when idle but dies when introduced to timber Sounds like the saw is running lean. Check the fuel filter, air cleaner and ...
Question about Wild Thing 2375 18" Gas Chain Saw 2.5 Cuin
...chain and idles insanely fast when I have the choke pulled out. Then when I give it throttle it calms down and then I can barely keep it idling. with throttle all the way pulled it dies, with no ...
Question about 2010 550 H1 EFI TRV 4x4
...Chain Saw Trimmer Parts Could be that you are using more power than the battery can handle with winching and lights. Best to run in low gear to keep the RPMs up to keep the battery charge up. ...
make sure your chain brake is off, screw in the idle 5crew, the saw will rev and the chain will start to turn. Now back the idle off until the chain stops moving and the engine is ticking over nicely
Usually answered in minutes!
627 Questions
549 Questions
535 Questions
166 Questions
208 Questions