Questions & Answers for: chain saw hard to pull

chain saw after using it, is to run the saw out of fuel, this will remove all fuel left in the carb and tank. If you feel brave, and you have a compressor handy, you can carefully remove the lines and

...chain saw doesn't retract pull rope The recoil spring on homelite chain saw doesn't rewind the pull rope. Also the pull rope pulls hard. Took it apart rewound the spring and put the pulley with rope ...

...or the chain is too tight To reset chain brake pull the guard hard back toward the handle and I mean hard! They have a really strong spring and you should hear a "clack" when it resets Hope this ...

...chain smoking could be due to several problems. 1. No bar oil in saw, or oil delivery problem. 2. Plugged oiling hole in chainsaw bar. 3. If it has a oiling bulb that requires manual operation, you ...

...chain saw always cuts at an angle I try to make a straight cut but my chain saw always cuts at an angle. I replaced the bar and sharpen the chain but the problem still exist. What should I do? a lot ...

Chain saw won't start - pull starter pulley hard to pull? If it worked fine the last time you used it, then pull the spark plug and try pulling the rope. See if it's easier or if gas shoots out of the

...increasing the compression ratio causing this to happen. When the spark plug is removed it is very easy to pull on the cord in any means. A inspection is due of this engine or a new chain saw is ...

...chain saw XL925 cord pull too hard but if you remove the spark plug then it pulls OK. I have a Homelite XL and was having problems with rope pulling from difficult to unable to pull rope while trying ...

Saw starter pulling too hard to start. Starter pulls so hard I can't hold saw down with my foot and will rip starter cord from my hand. This saw does not have a decompression valve. Remove ...

chain saw 450 rancher, I think is drowned, How do I find a solution? Starting any chain saw can be a bit finicky. How many hours has the saw done since new ruffle? Over about 10 and the saw would have