...master and the cdrom is slave...check your cdrom,at the back there's an indicator which type of connection you have.slave (sl)-cable select (cs)-master (m).put the jumper on slave.connect it to the ...
Question about P4S8X-MX Motherboard
...Have the DVDROM set up by itsself as Master on the primary IDE channel, the CDROM as Master on the Secondary IDE channel, and the ZIP as Slave on the Secondary IDE channel. Hope this helps! ...
Question about Motherboard, GeForce 6100, Athlon 64 X2, MATX, Max 4GB DDR2, PCIEX16, 2PCI, FENET, Vid, Aud, SATA3Gb (M2N-MX SE PLUS GREEN)
...your harddrive and cdrom are set correctly too. For example if your harddrive is set to master and your cdrom is set to slave, change the cdrom to master and harddrive to slave and see if this
...an IDE cable for the two CDROM drives. The CDROM at the end of the data connector is to be set as master, the 2nd CDROM connects to the next IDE connector & Its jumper is set to slave. Good luck! ...
Question about 661FX7MI-RS (661FX7MIS) Motherboard
...cdrom you have inserted recently and that has the jumper setting to Master, so that there is a conflict that the motherboard can not solve. Check the labels on disks for setup the jumpers so that the ...
Question about / 80GB / 7200 / 8MB / SATA-150 / OEM / Refurbished with NCQ (RB6B080M0) Hard Drive
...unable to boot the system. Hard disk is not responding have you check the jumper to see if there are master or slave settings. depending on your cdrom make sure if one is master the other is
Question about SM 352 CD-RW/DVD-ROM Burner
...Master 40E MODEL SC-140. FCC ID A3LSC140B Thank You When you look at the cdrom driver connectors, the following are the right jumper setting for all CDROM drives. Left - Cable Select Middle - Slave ...
Question about SM 352 CD-RW/DVD-ROM Burner
...master and the cdrom the slave. Some systems are now set to "cable select" that means that the hard drive ribbon has a master connector and a slave connector and that the device (hard drive or cdrom) ...
...master and cdrom to slave. The cdrom is marked on the back as to which jumpers you use. MS/SL/CS. master/slave/cable select. The hard drive usually has jumper settings on the front of the drive but ...
...master for the CDROM drive. Isolate them. Making sure one is master and set to accept a slave drive using one cable for both hard drives and one for the CDROM drive. Try that and see if this assisted ...
Usually answered in minutes!
19,138 Questions
12,216 Questions
7,310 Questions
7,277 Questions
5,472 Questions