Questions & Answers for: causes water stay washer

...water i mean it goes in and right back out and does not stay in, not even a little. the drain pipe in the wall needs to be as tall as the cabnet of the washer. if it is the see how much hose is going ...

of ammonia after the washer is full of water. DO NOT USE AMMONIA IF YOU USE BLEACH IN THE SAME WASH!!! IT WILL CAUSE CLORINE GAS TO BE RELEASED!! If bleach was used in the previous cycle it will be ok

water fill temp. After washing a load with hot water I switch to cold water for next load and the water temp stays on hot. Intermitently (back & forth) switching to cold, sometimes! check to make sure

stay in spin mode washer drains then starts to spin, after a couple of revolutions starts it to cycle on and off the spin cycle. Blew into the water level switch it works machine turns on and off when

...water, remove hoses from back of washer check the screens to see if they are full of sedimant.if they are just clean them out. make sure you don't get tempted to leave them out. if there is sedimant ...

...tub causing some water to stay trapped and causing the smell, try running some loads uning Ahfresh or you can try pouring lots of bleach in there and letting it sit a while, then run it throu a

...of water. I know you are supposed to clean the lines, but I dont knw how and does anyone know what is causing the water to stay in the softner compartment? Thanks! Contact our washing machine ...

...water is now just cascading into the exhaust system. What causes the thing to stay on is a collapsed microswitch in the sensor biscuit, or the tube leading to it is clogged. Have this level switch ...

...a cycle, Pull back rubber housing inside after each wash and dry it with a towel. Once a month use AFRESH tablets to clean the washer.Water stays stsgnasnt in rubber housing causing musty mold

water doent stay in the washer for washing it gets drained out Is the standpipe/Drain hose higher than the machine?  If not, this will cause the water to drain.