Questions & Answers for: causes rpm needle jump back

...back and forth and the engine starts to stall and takes a while to regain speed. Any suggestions? DOES YOUR SPEEDODOMETER HAVE A NEEDLE OR IS IT DIGITAL? IF IT HAS A NEEDLE, THERE STANDS THE ...

Ad

...rpm range. The speedometer needle jumps higher when the sputtering occurs even though the car's speed is not changing significantly. The check engine light is not illuminated and a code reader shows ...

Ad

needle. 5. engine will not start unless I jump it. 6. Replaced voltage regulator engine started right up with jumping ran well charging normally. 7. revved the engine then same symptoms all over again

Question about 2001 Monte Carlo

1 Answer

my car is surging when going up a hill the rpm jumps up and down it feels like you are being **** back and forth i am having the same prob with same car/year did you ever find out what was causing?

...needle on my Audi A4 jumps back and forth between empty and half when the gas gets below a half tank. Can someone explain what causes that to happen? This car was just purchased for my son. When ...

...needle for the RPM jumped back and forth for a few seconds, then went to zero. After pulling away from the drive and up to the 1st stop sign, the needle finally started to move between 1 and 2. Is ...

Question about 1997 Accord

1 Answer

...RPM's jump during shifting of gears,no service lights on,cruise control on during hwy speeds - the RPM's jump 100,never more than that,then come back down;goes back and forth,trans doesn't slip while ...

RPM and MPH needles got stuck together but went back in place after I tapped on the panel. Why is this happening and how can I fix it. This is common, it happens to mine too. One fix is to disassemble

...back and forth widly? Needles for gas, rpm, temperature, and mph will start flipping back and forth while driving. I had almost the same problem. but my gas guage would stop and say i had more gas ...

Question about 2000 Alero

1 Answer

rpm needle? The car shakes and the rpm needle jumps up and down it(the rpm needle.) doesn't stay at one which is normal. the rpm gauge works off impulses from the coils /ignition module. Fix the cause

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...