sewing machine problem No problems until today. The fabric advances, needle goes up and down, but no stitches are made. Thread just stays on top of material. Not knowing what type of machine you have ...
...advance the material being sewed. Fabric will not advance, causing thread to jam up. The teeth are all the way up and everything is clean of lint. The machine feeds fabric if I trial run it through ...
Question about 15218 Mechanical Sewing Machine
causes the feed dogs to pull the material forward. To adjust the feed dogs there are different ways to be adjusted. I wouldn't suggest you try to adjust the height of the feed dogs. On the top of your
Question about 15218 Mechanical Sewing Machine
...material does not fully self feed through the needle, is there an adjustment for this? Unable to locate much information about your make/model machine. If your machine has the capability of dropping ...
Question about 2037 Mechanical Sewing Machine
...advance the tension right up to a point where there is a slight resistance when you pull the thread through the needle Sounds like what is normally referred to as "bird nesting" or thread nesting ...
Question about 2037 Mechanical Sewing Machine
...MATERIAL THROUGH WHAT COULD BE THE CAUSE? It sounds like you might have a broken drive gear. Check that the feed dogs are in the "up" position for sewing (not dropped for darning). Also, verify that ...
Question about 2037 Mechanical Sewing Machine
...material serial N124610184 Check that the stitch length is set high enough that the feed dogs will actually advance the fabric. Setting the stitch length too low will cause the machine to basically ...
Question about 2037 Mechanical Sewing Machine
...advance material...what can be wrong? An older mechanical model? How long since it has had a thorough service? Could be old dried out oil is causing it to seize. Wheel on right side that controls the ...
Usually answered in minutes!
760 Questions
764 Questions
564 Questions
565 Questions
372 Questions