Questions & Answers for: causes blower motor bad

...blower itself, it can cause the resistor to become hotter than it was designed for. Less common causes are restriction in air flow in the heater box (resistor is air cooled) or gross overcharge ...

Ad

...inside the blower box to keep it cool,look for a bad blower motor that caused it to go out,it may not seem to you that it is bad,,but it is drawing too many amps,and causes the resister to burn

Ad

Question about 2005 Grand Cherokee

3 Answers

causes this is a bad blower motor,it may run good and sound good,but it is drawing to many amps,and is burning the resister out,this is your speeds.If this was at all helpful,please rate,and thank you

...blower motor speed control resistor, the resistor is located near the blower motor. You need to replace the blower motor resistor. That is what is bad, only allowing the fan to operate on

...BLOWER MOTOR RELAY IT COULD BE BAD OR BLOWER MOTOR RESISTOR BAD HOT BLOWER MOTOR TO SEE IF BLOWER WORK IF NO YOU HAVE FAULTY BLOWER MOTOR. IF BLOWER MOTOR WORKS WHEN YOU HOT WIRE BLOWER MOTOR CONTROL ...

Question about 2002 Town & Country

1 Answer

...BLOWER SWITCH STILL NOT WORKING . COULD THERE BE SOMETHING ELSE THAT NEED TO CHECK OR REPLACE. A poss bad blower motor or blower motor resistor can cause this. Replace the blower motor resistor

...or the motor itself. yes a bad resistor will. but also check the blower motor Probably motor itself, you can sometimes smack the blower motor and it will start running although it wont last

Question about 1999 LeSabre

2 Answers

...causes component failure. Check for power at the motor itself. Test the connection to the blower motor. Test the switch.------------------------------------------------------------------- Car ...

...blower motor only work on high Blower motor resistor is bad could be outside by the blower motor under the hood unless blower motor is under the dash it plugs in the box has 2 screws . If the blower ...

...blower motor melted 2002 dodge caravan Buy a new pigtail and splice it in. Make sure you run an amperage draw test on the blower motor to make sure it's not the cause of the melting. I would say bad ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...