Questions & Answers for: cause cam sensor failure

...cam pos sensor located in the distributor and ran fine. 13 mos. later, the problem repeats itself. After another sensor replacement and anothe 10 mos. the same failure. How do we diagnose the ...

...SATURN LS WITH THE 2.2 ENGINE HSA NO SPARK WHEN TRYING TO START there could be few reasons of cause spark failure. 1. timing belt broken 2. crank sensor failure 3. cam sensor failure 4. coil ...

...cam cause it to shut down while idling? The answer to your question is "YES" and "NO".  What I mean by this is a couple different things.  Yes, the cam and/or crank sensor can cause the ...

cam sensor .ended up being a cracked flexplate that shifted enough it was screwing with crankshaft sensor.the sbec(brain box) was going nuts trying to figure out why cam/crank signals didnt jive so it

...Cam Sensor Failure Causing no Start or Stalling. ... On the 4.7L V8engine, the Camshaft position sensor failure can cause the engine to crank but not start or it can ... On the 5.9L V8 engine, ...

...cause your car to die. I would direct your diagnosis in the direction of the cam shaft sensor. the cam sensor input is used by the computer to determine ignition timing and if the computer loses that ...

cause your car to stop running while driving? failure of the timing belt failure of either cam/crank position sensor immobilizer cut in battery failure / broken battery lead blown ING fuse out of fuel

cause it to shut off while driving. cam/crank position sensor/s problem broken wires to the sensors, problem ignition control module ECM failure immobilizer problem faulty ignition switch ( GMC recall

cause a p0340 and p0320 code code p 0340 refers tocamshaft position(CMP) sensor A bank 1-circuit malfunction===causes --wiring---CMP--ECM code p 0320 refers tocrankshaft position (CKP) ) sensor/engine

...cause is cam belt , snap,/slips/fails) ending accurate cam timing and SPARK. (even causing no spark at all) if all park plugs are dead. (tested) we check that the cam belt is not slipped first, for ...