Questions & Answers for: cat pump pressure adjust

...Cat truck mount water pump to arrive. I have a newer Husky 1750 psi portable power washer. Is there a way to regulate pressure coming out of the pump via a cheap 'dump' valve? Instead of using a ...

Ad

...Cat ZR 600 Snowmobile dies out My snowmobile will start and idle fine and run ok for a bit but then dies down unless I really feather the throttle. It is like its not pumping enough fuel pressure and ...

Ad

...pump/ check egr valve /test either clean repair,replace/check carb-throttle body clean repair/check cat converter possible clogging check for plugged fuel filter,and fuel pressure,i have seen this on ...

Question about Pressure Washer PSI 3000

1 Answer

...cat pump powered by a 13 hp honda engine I can not seem to be able to adjust the unloader valve to give me pressure over 950 psi and even at lower pressures, the pump will not deliver consistant ...

...pump seems to have plenty of pressure when i hit the pressure release, good batt 2 possible reasons 1 check ignition timing and adjust. 2 check for crossed plug leads on 2 cylinders --firing

Question about 3800 PSI Pressure Washer

2 Answers

pump not a cat thanks Joe. You checked the output to measure 5 GPM? How are you feeding that unit? What are you using for detergent? Have you adjusted the bypass valve? It's the gas cap. The cap won't

...cat. if the jakes or out of adjustment can it drop oil pressure please help thanks highly unlikely, the jakes are just valves in the cylinders that open to let the compression escape the piston ...

...Pump or Barometric Pressure Sensor (MS43) • 197 EVAP -Barometric Pressure Sensor • 198 Cat Efficiency during Start -Bank 1 • 199 Cat Efficiency during Start -Bank 2 • 200 Lambda Regulation Bank 1 Pre ...

...pump/ pressure regulator---injector/s---heated oxygen sensor (HO2S unit in the exhaust manifold or before the cat converter If the engine is running well then consider replacing the HO2S unit as that ...

...pump---injector/s ---HO2S ( heated oxygen sensor in the exhaust manifold before the cat converter as the HO2Sv is the principle reader of the exhaust gas composition and reports to the ECM to adjust ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Garden Experts

Jay Finke
Jay Finke

Level 3 Expert

1397 Answers

john h

Level 3 Expert

29494 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...