Question about Wild Thing 2375 18" Gas Chain Saw 2.5 Cuin
poulan saw hard starting after carb rebuild what are the initial settings for high ,low carb screws .mine are now adjustable after overhaul Through trial and error on fairly new Poulin Pro, found that
Question about Wild Thing 2375 18" Gas Chain Saw 2.5 Cuin
...carb low idle needs to be adjusted this is fairly common among the Poulan chain saws. Once you adjust the low idle from factory setting it will work Also, increase the amout of oil you're putting in ...
...poulan carb. A standard screwdriver will not do. Model #P4018 WTL I just finished looking at mine and I think they made it that way so back yard mechanics dont tinker with it. If there is a Poulan ...
Question about Wild Thing 2375 18" Gas Chain Saw 2.5 Cuin
carb adjustment for a Poulan Wild thing 2375 Start at 1.5 CCW from lightly seated then tune for performance like this: Carburetor Adjustment by Madsens.com ...
...carb adjustment issue, however there is a special tool required to adjust the mixture, part no. 530035560, once you have the tool richen the L scerw on the carb by unscrewing it by 1/4 turn out, ...
Question about Wild Thing 2375 18" Gas Chain Saw 2.5 Cuin
...this is why you only have a small amount of adjustment, you may need to remove these to adjust the carb properly, if there are any splits or cracks in the fuel lines the saw will not run
...Poulan " Wild Thing " 20" bar + chain stalls under load, removed chain and bar, Saw runs fine ? It is running lean, they always need to run a little on the rich side free running, once ...
...the high and low. Unfortunately, Poulan has limiter caps that require a special tool not available to consumers. To get the carb adjusted properly, you will have to take it to a local poulan
Question about 18" Wild Thing Chainsaw
...poulan wild thing 2375 chain saw that bogs down when cutting and is hard to start? there are two screws on the carb start by turning them all the way in then 3 full turns out and then make half turn ...
Question about 18" Wild Thing Chainsaw
...carb itself will be three adjustment screws, an L screw an H screw and a T or I screw, the latter screw will be the idle speed screw, by screwing it in clockwise it will act against the throttle ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions