Questions & Answers for: car idles good bogs down

...good car. Lately when I am going down the road sometimes it will bog down when I accelerate, to the point that if there is a hill I can not keep the speed up but it runs fine at idle. Recently I ...

...good, idles good but bogs down when accelerating. I've changed the fuel pump, sending unit, fuel line, mass flow air sensor, plugs, wires, cap, rotor button, TPS, intake temperature sensor, coil. I'm ...

but that did no good. it idles just fine but as soon as you hit the gas pedal, it bogs down and starts knocking a little. this problem just started one day out of nowhere First replace the fuel filter

...idles fine but normal acceleration and cruise is nearly impossible. Bogs down at all speeds. Hard acceleration is fine goes good. I had the same problem with my 89 grand am it was caused by a faulty ...

...idles?!!?? Your only problem friend, is the temperature sending unit/sensor. Upon cold start, this sensor wil tell the computer to go into cold start mode putting a bit more fuel in and raising the ...

...idles good a little low but good but when accelerating motor bogs down and tries to stall. is that my M.A.P. sencor? I have 1999 Dodge 1500 gas motor. It has a high idle and when I let off the gas it ...

car idles fine but when you step on the gas it bogs down, and won't accelerate. The car will not go over twenty miles an hour. what year. ever tune it up, no, then the fuel filter i packed, air filter

...Idles good tho Car bogs down when accelerating and hesitates. Help!? ' Yahoo Answers https://answers.yahoo.com/question/index?qid... Aug 23, 2012 - I get the car back and it does not want to ...

...right up, idles good, take off and low speed good, bogs down at higher speeds, does not want to go. run the fault codes indicates a blocked cat converter , low fuel pressures or MAF/VAF sensor ...

Car starts and idles good, when accelerating it bogs. 2003 Nissan Altima 3.5l I replaced the vvt solenoids, found the timing chain tensioner extended all the way out and the plastic guide was slid ...