Questions & Answers for: cap on axel

...axel to drill out any help would be welcome you don't have to remove the whole axle just the hub assembly this is held on by 4 bolts. remove wheel. then remove drum/ or rotor remove all the brake ...

axel, but wshere doe other end plug If its about 3/8" thick and attached directly to the axle tube it's the vent line which belongs tucked up on the firewall. It usually has a little vented cap on it.

...cap and inspect all the hose and connection's to the EVAP system. that is not your problem, the hose on the rear axel doesnt connect to anything, Its a vent for when your rear axel heats up it wont ...

cap on the side and the screw. How do you remove the pod section,this is an older model a pol vac plus. thanks I will usually use a large screwdriver. Wedge it in at the axel of the pod and gently pry

...cap. remove caged locknut assembly (38mm socket i think.) then pull the hub assembly from the axel. you may need to cut away the inner race if the bearing falls apart. clean axel, apply alittle anti ...

cap and screwed on plate on the end of the axel. It looks like I have to unscrew the plate &/or then remove the nuts on the end of the axel. ??Will I need to remove the axel to get the hub off, or

Torque specs 2009 ultra Axel and end cap nuts Hi Anonymous, axle nut 50-55 ft lbs. end cap nuts 11-15 ft lbs. Have nice day.

...axel and then tried to put the bar in but it would not fit the I realised you had to slide the bar through but now I can't get the axels of how can I get them off? Ok! I can relate to all the ...

...axel cap doesn't seem to tighten up flushly against the upper mount is this normal or is their a flat spot on the axel that has to line up? It doesn't mount flush because it butts up against the ...

axel or need to seperate ball joint,does seal itself just pull out or is there cap,collar or anything wierd Hi,if you are talking about the drive shaft cv boot,there is a vidio on you tube showing how