Questions & Answers for: camaro ecm

1995 v6 camaro wont start it will roll over but wont crank check for spark, then check and see if its getting fuel and check the fuse to the ecm

...camaro just started to idle to high what could it be What about if u check the signal going to the ECM with the full throttle it should be 5 volts, a good TPS should be between 4.5 & 5 VDC but u will ...

camaro: fuel doesnt make it to tbi??? cranks but no start??? change fuel filter .if its okay check fuel pump pressure.make sure your ecm is getting power. you should see check engine light no when you

...ecm you can swap it only if the other Camaro is the same fuel system (TBI for TBI or multiport for multiport).I've done this quite a few times.The Ecm is under the passenger side dash area where a ...

How to change a engine control computer on a 1988 Cameron 2.8 v6 disconnect battery ecm under dash passengers side.remove computor(ecm) there is a little trap door remove it.there is a chip in it that

camaro iroc-z tpi 305 manual. checked grounds to ecm all are good and engine ground. have new pickup in distributer have signal to ecm from pickup wires are good, checked injector harness for short to

...ECM on your camaro has one (1) injector driver in it. This drive splits to 2 traces inside of the ECM and exits on 2 separate pins. Each bank of injectors has its own fuse. So a fuse may have popped. ...

...ecm in a 1999 V-6 Camaro with a used one. Now the speedmeter goes much higher than actual speed of the car. Idle is very high. Can't drive on highway at all. What's the deal? Switched out the ...

car stalls out at 2000 loose power from ecm/pcm car stalls out at 2000 loose power from ecm/pcm to ignition module at 2000 rpm making the car stall out replace ecm the ecm is shot

...camaro z28 that will not rev over 3000 rpms In any gear. It acts like I hit a rev limiter. I have replaced the tps, plugs, wires, icm, coil and distributor. And it does that same thing. Most likely ...