replaced a 96 mustang 3.8 engine with a 95 mustang 3.8 engine. engine won't start . No spark check your cam positioning and crankshaft positioning sensors
...cam position sensor and all 4 o2 sensor's on a 01 ford mustang gt with a 4.6 Code P0340 is a camshaft position sensor CIRCUIT fault. This means it can be a bad sensor, wiring fault (loose connector, ...
how do i locate and change a cam position sensor Look at the heads there should be a black sensor bolted to one of them. I think its a 9 mm bolt.
Question about 2000 Mustang
2000 Mustang: which is the position for the wires for the sporck... Which is the position for the wires for the sporck plug For the 2000 Ford Mustang: Based on your question you should have the 3.8L ...
...generated by the camshaft position sensor Possible Cause--- Cam Position Sensor Powertrain Control Module ETC,MAF,CKP Verify CMP is installed correctly You need a local repair shop to check it ...
Why does my 2000 ford Mustang Saleen fluctuate RPM's at an idol and while driving? could be cam or crank sensor. CEL light on too?
cam shaft position sensor, replaced cam shaft position sensor, cleared codes, light comes on again, the code reads cam shaft position again as well as engine running lean. Kwik Kar cleared those codes
Cam Shaft Position Sensor. Then my RPM gauge worked then stopped working then worked then not. I was driving my car and the stereo and AC quit working then restarted again. When I restarted my car, it
Question about 2003 Mustang
...cam/crank position sensors have ONLY been unbolted and replaced with new sensors, do they require synchronization? Error code P1336. Cam or crankshaft HAS NOT been replaced. Only sensors. Sensors do ...
...Position Sensor Intermittent https://www.engine-codes.com > p1125_ford Faulty Throttle Position Sensor · Throttle Position Sensor harness is open or shorted · Throttle Position Sensor circuit poor ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions