...cam gear there will be a mark on each sometimes they look like a dot the dots need to look like this for perfect timing ( . . ) this will be there closest position. Your crank turns once all the way ...
...have 18.5 briggs. lining up timing dot on cam an crank gear,is it dot to dot or is there marks on case It should be dot to dot. All marks should be on the gears only. I hope this will help you. ...
cam dot/TDC indicator in the 12-O clock position, the two dotted links should be on ether side of cam dot, turn crank dot to the 6-O clock position and line up highlighted link with dot on crank gear,
...dot, left bank with 2 dots on the shaft itself. To align the camshafts to each other each cam shaft gear has a mark on it. Draw an imaginary line between the centre of the camshaft and the centre of ...
need to know where to set tmming marks crankshaft mark, 12 oclock, cam shaft mark, 6 oclock. Cam mark needs to be at 6 oclock and the crank need to be at 12 oclock, Dot to dot, Good luck to ya.
Question about 1985 S-10 Blazer
...cam gear dot at6 and crank gear dot at 12 and on tdc compression stroke it points to number 4 on cap when cam dot at 6 o clock i lined up gears at 6 o clock cam and 12 o clock for crank dot and im ...
...dot which marks top dead center. A flywheel is balanced and does not need a mark. However if the wheel you refer to is a cam gear (one or two gears depending on how many cam shafts your engine has) ...
...and cam gear,you will see a single dot and then 2 dots about 10 cm apart,use that dots to align,then align your crank,you will see it from top when you look at the crank gear that holds the cam belt ...
Question about 1985 S-10 Blazer
...gear face of cams, and the locate marks on cam caps...and dot on crank gear is on the face, not behind...always no matter what engine or belt or chain...the dots will line up with dowel pin on ...
Question about 1985 S-10 Blazer
...crank and cam(s).
The chain markings shift depending on the number of links in the chain and number of teeth on the crank and cam gears, but the number of links (rotational distance) between ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions