Questions & Answers for: Pontiac cam belt

...if it does, then transfer the marks to it. These have got to be right or I will give your engine about 11miles. Clamp down the cam pulley before you remove the old belt, they have a tendency to

...would like to changing head gasget on 1997 sunfire would like to know about the timing belt 2.2 engine 2.2L doesn't have a timing belt it runs on cam,push rods and rocker arms.2.4L runs on timing ...

cam timing can be checked by removing all necessary components to gain access and remove timing belt covers rotate engine till #1 cylinder is @ tdc on compression stroke and check to see if all timing

...belt on a 95 pontiac grand prix with a 3.4 v6 The 3.4 is very difficult. If it has the twin cams you will need to have a very clear process worked out for you. One cam needs to be held in place while ...

...belt cover to line up the cam sprocket. A tab is on the lower to line up the crank pulley.
If replacing oil pan gasket you need 2 gaskets as this engine has a windage tray. The oil pump pick up ...

...belt or chain. The cam and crank should be precisely timed together. If the PCM detects that the Crank and Cam signals are out of time by a specific number of degrees, this P0017 code will set. ...

...belt or the cam? If it's the belt, there should be 3 lines on the belt. Put the belt on the cams and turn them until all 3 of them line up with the timing marks on the cams. If it is a timing issue, ...

...belt was removed and engine was turned over briefly. Crank seal was changed now car will not fire. Without tearing it apart...How to get crank, cam,etc back into time? Is it possible? Side mounted ...

what a night mare job
which 4 cyl 2.4 engine is fitted to that
chain or timing belt

normal cam cogs or
a 2.4 ecotec with VVti cams timing chains
possiblty twin cam

.

belt or chain? that's easy but no VIN told that tells what engine is there. two V6's cam timing, 3.1L and 3.4L (3.1L pure chain and push rod valve.) in the block cam then 3.4L is LQ1 , RPO code engine