Questions & Answers for: cam belt

Ad

Question about 1995 Pathfinder

2 Answers

belt on the driver side cam and crank, and then put it on the passenger side cam. You'll need to lock the tensioner clockwise about 70-80 degrees to get enough clearance to install the belt. should be

Ad

...cam gear & the belt was left out.Good luck, ChevRev P.S. This should be a round metal collar with a curve towards the cam gear to keep the belt from riding towards the cam gear .Without it the belt ...

Ad

...cam belt prob at 50,000 miles My 2006 Elantra engine is a bit noisy - could the cam belt need replacing after 80,000kms? Do you mean the "Timing Belt"? There is NO Cam belt.. .there is, however, a ...

Question about 2004 Focus

2 Answers

...where a cam belt would need to be changed. timing belts should be replace at 60,000 miles. ithe focus is a belt i have a 2005 ford focus hatchback 1.6 tdci, does this have a cam belt or chain

...in certain spot as well as timming mark on belt driven cam gear to cover this cam gear is a 3:1 ratio (3 turns of cam gear = 1 turn of cams) i am putting the timing belt un time but my car dont turn ...

...cam belt cover remove top cam cover retainer clip in top centre if still there and then 10mm bolt in cam belt cover just down from top middle section of cover bend gently to get to cam sensor bolt if ...

...cam belt situated on daihatsu sirion. Is it adjacent to the fan belt?. Would the cam belt affect the power steering? THERE IS NO CAM BELT , THE TIMING BELT IS TURNED BY THE CAMSHAFT , THE POWER ...

belt on cam till you have it on IF THERE ARE NO CAM THRUST BEARING PROBLEMS THEN YOU NEED TO BRING THE TIMING MARKS UP THERE IS A TOOL FOR LOCKING THE CAMS DOWN THEN YOU INSTALL THE BELT STARTING FROM

Question about 1995 Camry

1 Answer

...cam belt that must be replaced every 60,000 miles. The cam belt also drives the water pump and for this reason I recommend you replace the cam belt at 120,000 miles when you replace the cam belt the ...

Question about 1995 Camry

1 Answer

cam belt broke or teeth stripped off of old belt, which unfortuneately means removing the cylinder head and getting it repaired (valves replaced and possibly guides) see some of my other posts for cam

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

84966 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

john h

Level 3 Expert

21069 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...