...kill the running engine.First check the switch with a measure apparat.Then check the continuity of the two wiring harness,sepparately.One wire is atached to the ignition module with a screw and goes ...
...kill switch and that did not work. The wire and connections look fine. I assume the ignition coil is ok since it starts fine. Anyone know what it could be? Hi, OK. The kill switch breaks the circuit ...
...KILL SWITCH WIRE THAT COMES FROM THE IGNITION MODULE generally the wire goes to the kill switch which in turn is screwed down to the body of the saw creating a ground when switched to the off ...
Question about Stihl Garden
...kill switch need to be connected in order for the chainsaw to run? I was given a chainsaw and the kill switch wire was disconnected. Does it need to be in order to run? The on/off switch must be ...
Question about 288 Kill Switch Wire Chainsaw Chain Saw
...kill switch on a husky 288 xp There should be only 1 screw and one wire connecting the kill switch. The kill switch simply grounds out the ignition. So it is difficult to install improperly. The wire ...
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
where does the kill switch wires go Coil too the kill switch , kill switch too the ground good clean metal.. Kill switch is just making the ground conection.. Goodluck..
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
...kill switch wire, .010 gap module to magnets. Still no spark. The only saw parts for ignition are coil, flywheel and spark plug, correct? anon re connect the kill switch. If this fail try connecting ...
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
...kill switch, so if you disconnect them, it will bypass the switch, see if that works, if not, check the wires going to the coil under the flywheel. Sometimes they come loose and or get caught by the ...
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
bypass kill switch on a 2013 Polaris outlaw 50cc? a kill switch either "makes" a circuit or "breaks" a circuit.., so - you can do one or the other... connect the two wires or disconnect the two wires.
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
type of kill switch you have... one type kills (breaks the hot wire) the connection and one type makes the connection to ground..(grounds it out).. try to bypass the kill switch to see if it will run.
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions