Questions & Answers for: burned wire ac capacitor

...ac and locate the wire of blowing fan.Check how many leads make sure to make sketch where it was connected from low,medium, and high there is coded color on it,discannect from the terminal, using ...

...ac compressor Is this a 3 phase compressor? If it is it will have markings L1 - L2 - L3 and it will not have a run capacitor, then just reverse any two compressor wires. If it's single phase then you ...

burned, you can often cut them back to clean wire and reattach. If these look fine, remove the entire cover and inspect the 120V wires at the relays. If they are burned, replace the control unit. Hope

...burned up. AC does not work now. Does the RC = Run Capacitor usually just burn up ( fried a terminal off ) or does some other component usually cause the RC to burn a post off ? Could be; ...

...AC/Heat pump. Model# 661CJ030-A. Problem: Air conditioner not cooling,fan comes on,there is a click and a hum but compressor doesn't come on to cool. Does thermostat have anything to do with this or ...

...burned wire inside the unit - to a shorted compressor or fan motor. If you're mechanically inclined you might open up the unit and see if you can find more burnt wires. It does worry me a little when ...

...capacitor) to Air Conditioning Supply House and purchase an exact replacement. As to the diagram. There should be a schematic on the unit - somewhere. Usually located on an 'inside' panel. Unless ...

...Ac the commpressor does not seem to be kicking on fan works any thoughts. Several things can cause this. The most common are a bad compressor, burned off wires, and bad capacitors. Turn off the power ...

...burned up35/UF motor run capacitor +-5% 440V-60HERTZ,has 2 round pins with 4 plug in slots on each have six wires to attach to capacitor Hi, if the first 35 uf run cap shorted, you most likely have a ...

AC mode but reverses the blower motor in heat mode and burns it up Could have been a miswire at the time of installation On your control card for your furnace check the fan motor taps for power supply