Questions & Answers for: brush assembly

Ad

...Assembly" for the brush roller 61445-1. The roller brush is in perfect condition except for one of the "Bearing Assembly's". It is not practical or wise to replace the whole roller brush because of 1 ...

Ad

Question about SteamVac F5914-900 SpinScrub Upright Vacuum

1 Answer

...brush assembly if I knew that was the problem. One of the latches snaped off some time(?) and the brushes are wearing down. The brush assembly does fit back into place and every thing else seems to ...

Ad

Question about F5906-900 Upright Steam Vacuum

1 Answer

...brush assembly out by holding the two tabs, and all seems clean and the brush assembly rotates easly... onced the brush assembly is removed. What I did notice is the female driver slot (found in the ...

Question about SteamVac Carpet/Upholstery Deep Cleaner Vacuum

1 Answer

...assembly. Clean the lint screen first, then try to turn the brushes by hand. If they will not turn by hand remove the brush assembly, if the brush assembly turns freely the turbine may be

Question about F7425-900 SteamVac V2 Widepath Upright Vacuum

1 Answer

...brush assembly is broken. If the whole brush assembly keeps falling out, the drive pin shaft may be damaged. To order a replacement brush-block follow the link below. Search Results Hope this

Question about SteamVac F5914-900 SpinScrub Upright Vacuum

2 Answers

...brush block assembly That is impossible, unless the brush enclosure is broken. The brushes are enclosed in a cartridge (Brush Bock). You must replace ...

Question about Floormate H3000 Upright Wet/Dry Vacuum

1 Answer

brush assembly & then reseat the brush assembly. Before doing so you should remove both Tanks from your Hoover. Then there are two buttons on top of the Nozzle Assembly that holds the brushes. You

Question about SteamVac F5914-900 SpinScrub Upright Vacuum

1 Answer

...to rremove the brush roll Just pull the brush assembly straight out slightly and look for 4 release tabs....squeeze the tabs and pull the assembly out. Make sure cord is not plugged in. ...

...the middle stem (know as the brush block) and the turbine turns the brushes. Turbines cost $39.00 Brush Block Assembly cost $34.00 Called our store on Monday to order. 937 291 ...

...brush assembly on the max extract dual v other than running the assembly under water? The bristles are loaded with carpet fuzz and remains of doggy doo Following is the procedure for removing the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Vacuums Experts

AskDyson
AskDyson

Level 3 Expert

2572 Answers

Les Dickinson
Les Dickinson

Level 3 Expert

18429 Answers

D. Floyd Kolb
D. Floyd Kolb

Level 3 Expert

43501 Answers

Are you a Vacuums Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...