Questions & Answers for: broken microphone wires

...broken for the microphone on my lifechat lx-3000 headset. I want to just eliminate the inline volumn control and mute and hard wire the 2 ends together. does anyone have a wiring diagram for this ...

microphone has broken from the circuit board. you will have to open the phone(probably by removing battery cover and a couple of screws and re solder the broken wire.its not really a difficult job,but

...microphone is held in different positions. Could it be the cord or the connection to the mic? Make sure your connections are clean and tight. There may also be an intermittant or broken wire in the ...

...broken wires by very gently unscrewing the microphone head and peering inside - however the wiring is quite short so be careful not to pull any wires off in the process. A broken capsule can be ...

when i talk the other party is hearing big noise TRY TO CONNECT TO OTHER PC'S MICROPHONE JACK, MAY BE THE WIRE IS BROKEN OF YOUR MICROPHONE.

...Neumann U87 mike. The male plug pulled out and broke two of the three wires. Not sure where to solder the two wires that are loose. Any help. is it still broken? I would like to buy it, grtz ...

...are most likely---The 25 is a fairly trouble free radio. The microphone is the most common issue--broken wires inside the plug connection or a broken wire in the cable up to the microphone

the microphone is not working while the music works on the magic mic twist microphone cover. Inspect and solder broken connection wires from the microphone to the motherboard.

microphone head and the other was broken off the circuit board, there are no empty solder joints on circuit board. The other is most likely a ground. However you should use a good magnifying glass and

...microphone are broken how should they be connected? Microphone does ot work so I unscrewedthe mike head and found the wires broken, one black and one red. How should these wires be reconnected? ...