turn signals bleed thur gauges speed o slow to return the wire is grounding thru one of the bulbs, check the bulbs for bad elements, and broken or bent elements
Heated seats not working Passenger side seat heating element broken heated seats not working 2003 chevrolet suburban
...does the duty of turn signal and brake signal. The brake element/filament is probably broken, and not the turn signal element/filament. Replace the bulb with same model as broken one. Hope this
filament that does the running lights is fine, but the filament that does the brakes and signals is broken. Visually check the bulbs for broken filament
broken element in the bulb will do this when the element bounces up and down and makes brief contact. If you have tried this then it could be caused from a broken wire on the headlamp harness or a bad
headlights are on the left signal light doesnt turn on but still flashes when u use the turn signal Broken ground on that set of lights or the bulb is bad there are two elements in those bulbs for two
drivers side seat does not heat on my 2004 venture van. CHECK FUSE`S CHECK TO SEE IF POWER IS REACHING THE SET`S WHEN YOU TURN IT ON IF IT IS ELEMENT IS BROKEN INTHE SET`S
Question about 2009 Impala
...comes on for about 30 seconds then goes off seat wont heat. A common problem with seat heaters is broken heater elements. If you can get access to the connections you can check them with an ...
element is contaminated, deteriorated or has failed.Vacuum hose is disconnected, broken, leaking or loose.Trouble Code: P0174Fuel Trim System Lean (Bank 2)Possible Causes:Air leaks in intake manifold,
Question about 2010 Equinox LTZ
...dash indicates that is is on. What could the problem be? nothing except for pressing the dash button which lights up as if it is on. element may have broken circuit or wires to it have bad
Usually answered in minutes!
4,236 Questions
3,219 Questions
2,541 Questions
2,307 Questions
2,177 Questions