Questions & Answers for: briggs stratton engine wont rev

...cutting grass. When cutting grass the engine starts to blog down and engine starts to skip. Have set valves, new plugs, and cleaned the carb. Sounds like the blades are dull. HAve them ...

[with mower on high grass full forward] if you slow down alittel it will start to backfire. (1)You high speed carburetor jet is too lean (2) a dirty carburetor that needs cleaning (3) dirty air filter

briggs & Stratton 21 hp vanguard engine. carb is getting clogged and spark plugs fouling out every time i cut grass due to air filter being on front of engine. having to clean air filter and spray

Briggs and Stratton Engine wont start, it continues to turn over, but makes a loud bang, and won't run. I just got it back from the shop, it worked fine until it stalled in some tall grass, and I have

...Briggs and stratton engines are well known to come out of the box with the engines reving much lower than they should be. you will need to check and adjust the high speed engine revs to approx ...

briggs and stratton 190 cc toro lawnmower engine runs too slowly for mulching operation. How can I increase rpms? After cutting a short swath, the mower's mulching operation almost stalls the ...

...engine pulsing When the mower is running as I'm cutting the grass the mower slows in rev's to the point it almost stalls. If I stop and lift the mower slightly it regains power and off I go ...

...briggs revs high when in tall grass and imediately slows when in shorter grass but its real drastic and touchy when mowing lawns of different thicknesses of grass This sounds to me like a simple ...

engine is reving high enough to spin the blade fast enough to pick up the grass, typically your engine should be revving at approx 2900-3200 rpm of course if your trying to pick up wet grass then your

Briggs & Stratton 450 series 148cc. How to get higher revs? On full throttle it run good until it hits a thicker section of long grass. It just wants to die down in the revs department & wants to ...