...F1 bridge it and it should work Solution #2 posted on Feb 29, 2008 this was me homerweezy i had not register when i wrote this but i hope i helped you out if there is no power what you do is re soder ...
...BRIDGE.Its usually the F2 fuse,but after I had done this the DS would work but it would not charge.After a bit of fiddling I found that the F1 fuse had also gone and apparently this is for the ...
Question about DS Lite Console
...F1 Service manual; Classic Audio Equipment restorer Glenn (echowars) McDonald; Most Sansui literature.Hope this be of additional help/idea. Pls post back how things turned up or should you need ...
Question about DS Lite Console
...F1 fuse if the F2 fuse was also the culprit. Do the same thing to bridge the F1 fuse and then it should work. I checked both fuses and are ok? other idea? please help us!!! Regards ;) BROKEN TOP ...
...was on in order to bridge it because the fuse is probably blown. If that doesn't work then the other main fuse that could be blown is the F1 Fuse. Do the same thing to bridge it. Then it should
...bridge the fuses as once the fuses have been bridged there is no saftey shut off to stop more sever damage. oh by the way just youtube F1 and F2 fuse location to find out where they are. oh and use a ...
...bridge the fuses as once the fuses have been bridged there is no saftey shut off to stop more sever damage. oh by the way just youtube F1 and F2 fuse location to find out where they are. oh and use a ...
Question about Stylus Photo RX600 All-In-One InkJet Printer
bridge the F1 fuse with a tiny blob of solder - both systems work and have caused no further problems in the past couple of years. 8. Having a soldering tip small enough is vital if you are to attempt
...bridge the fuse to see if that is your problem. There are not 2 fuses connected to the charging but infct just the one the "F1" fuse, the other fuse you are refering to is the "F2" fuse which is the ...
...f1(which i assumed was a fuse)was open circuit i bridged it with a 100ohm resistor on checking i found 12volts at each end implying no current drain.I do not have a circuit.Any suggestions please? If ...
Usually answered in minutes!
19,138 Questions
12,216 Questions
7,310 Questions
7,277 Questions
5,472 Questions
