...a JBL GTO 600.1 in bridge, in the manual say cant be bridge the amp, how much power is in bridge at 1 ohm, can be dangerus if i ruing bridge? it will over heat the amp posibly blow ...
Question about HCCA-D5000 Car Audio Amplifier
...bridge my amp or not? what should i do with my subs? should it run in parallel or in series p.s. thanks to all the guys who answered my previous queries you've been very helpful thanks again the ...
Question about ELA500.1 Car Audio Amplifier
...when bridgeing an amplifier it always sees half of whatever load you have on it, so if you have a 4ohm speaker when it is bridged the amp will see 2ohms, so yes you can bridge the 4 ohm ...
...bridge the subs to the amp the protect light comes on but the amp works fine when subs are not bridged is the amp able to handle two 4ohm subs bridged? Thanks Are you setting the bridge switch for ...
Question about XM-1252GTR Car Audio Amplifier
...2ohms the amp is 2ohm stable .the L7 is a 4ohm dual voice coil when wired in parallel it goes down to 2ohms and when wired in series it goes up to 8ohm load right now i have it wired in series at ...
...amp do i need to power a Polk Audio db1040DVCin brigded connection, i only plan to run one sub, i want to bridge the sub for better sound quality, and i'm buying straight polk, what do i need Hello ...
Question about BAMF2200/2 Car Amp
bridge the amp then the volt meter on the dash goes down and the amp cuts off Hello munchisfun, I'd suspect that the amp is operating into too low of an impedance and going into protection. The 2200/2
...bridge the amp, you CAN run both subs as long as the amp is Two Ohms Stable. Wire each subs voice coils in parallel.(Positive to positve, neg to neg.) (2ohms) each. Then wire the two subs in ...
...bridge it to youre amp for 1-2ohms continous power....make sure youre amp says continous power at 1-2ohms if it says in the manuel not stable it will just cut on and off at its peak because of over ...
Question about PRS-X720 Car Audio Amplifier
BRIDGE IS BURN OR MY 2 CHANNEL? PLEASE HELP From the specs this amp can only handle 4ohms when bridged but can handle 2ohms when it's not bridged Specifications Continuous Power (20Hz-20kHz, 0.04% THD
Usually answered in minutes!
687 Questions
481 Questions
236 Questions
236 Questions
240 Questions