Questions & Answers for: box joint

joint or idle arm, or possibly the steering box? Steering works fine sitting still or at low speeds. 1.It isn't a lower or upper ball-joint, lower ball-joint, nor tie-rod end. A lower ball-joint being

...joint at steering box of a 1976 Doge D100 truck. Can you give me any information on how to do it ? first thing is to loosen the column mount at the fire wall inside where the column goes through the ...

...just need to get the u joint off the steering shaft hopefully without having to replace it. are you replacing the box or the steering shaft u joint?? you dont have to take the box of the do

...the outer part of the joint that go's into the gearbox, dont hold the shaft only hold the inner most part of the cv joint that go's into the box if it moves/ flops about its the bearing in the gear ...

...box. With the steering box disconnected the wheels should have almost no resistance to turning. Dont waste time, investigate immediately!! If a joint is siezed it may snap and cause you to

.../ loose steering Sloppy / loose steering. Scary! I wont drive it in traffic. Changed steering box (rebuild from NAPA) the only diff from original is much more assist. Made adjustment to new box ...

...this be cv joints or ball joints I suggest that it is neither but the problem is in the steering box or rack. Terminology is important when trying to describe a fault.. By locking up do you mean ...

94 tracer blower fuse where is it. book says joint box side Joint box, are you sure it says that?

...boodk says on joint box side not shown Joint box, are you sure? On this website (link below) you find fuse box diagram and description for Mercury Tracer Mercury Tracer fuse box diagram Auto ...

...box in the front and rear cause this? Next step is to remove the drive shaft and physically move the joints by hand. If there is any binding/stiffness, the joints will have to be replaced. Once the ...