Questions & Answers for: bose cd dvd player eject

...cord, wait 60 sec., then press oen to see if the CD?DVD is ejected. then you can turn the system back on. this will reset the unti, got that advice from the Bose tech support. works just fine for

the CD.. I took it apart to remove the cd. and noticed a pinched wire. Where can I send it to for repair. Send it to your Bose dealer. They always have back up service available...best ever. Good Luck

CD stuck in disk tray of (original) BOSE 321 I have an original Bose 321 system which I purchased in 2002 timeframe. Here is my problem. I have a dvd stuck in the dvd tray. When I hit eject on the ...

...dvd in the CD by mistake. The thing won't eject. It diplayes an error 3 code basically just carefully insert another CD into the slot, but only about 1 to 2 inches of the disk and keep jiggling the ...

...try to read the disc again If everything else failed, just changed the CD/DVD ROM. It is the same CD/DVD for personal computers. Bose uses hitachi, I replaced mine with sony and everything works

cd/dvd trays - gear/rubber of the tray transport worn out. manytimes it helps if you always keep a cd/dvd in the tray (don't keep the tray empty) it may also help if you can keep the bose 321 vertical

...cd tray Get auxilary cables (red and white) and connect another DVD to the Bose system. Use Video 2 for DVD on the Bose system). Connect another set of cables to the TV from the Bose system and use ...

bose wave one cd player) How can I get it out? open up paper clip and poke gently in to into the very small located on frontoff c/dvd this will manualy open drive,to remove ****. Cd put in upside down

...BOSE CD/DVD MACHINE WILL NOT OPEN TO ALLOW EJECTION OF A DISC. IT SAYS NONE IS LOADED. try turn off your unit then after one minute open it again if hese not work send your unit to the nearest sevice ...

Bose Lifestyle. You may try these steps to resolve the issue: Note: You will need a flashlight and a small screwdriver. 1. First, disconnect the base unit from the system. 2. Turn the base unit upside