Questions & Answers for: bosch aquastar 125b

bosch aquastar 125b ng flame keeps going out, will relit but when release button flame goes back out Replace the thermocouple. Thats the flame sensor. If the gas valve is not sensing flame it will not

...Bosch 125B manufactured after Feb 2005.. I think it is the thermocouple since it turns off the pilot as well as the main burner. It could also be the gas valve. These parts are expensive and non ...

Bosch AquaStar 125b ng suddenly goes cold during shower Taking a shower normally when it suddenly, for now apparent reason, goes cold. No one is running any water in the house. If I turn the water off

aquastar 125b ng: after 2 years of use water is not hot enough The water is now luke warm at the highest setting. Before the water tempeture problem developed the flame inside the heater goes out ...

Bosch 125b-ng water heather has low flame only The water heater only has a low flame and wont change to high to heat the water Did you check to make sure the shut off handle is on the on position?

Bosch aquastar wont get hot Have a 125B Propane and it gets warm but not hot. 1) If tankless is not showing error code, the problem might be single-handled faucet cartridge: ...

...Bosch Aquastar 125B Water Heater Repair Parts Pre January 2003 Bosch Aquastar 125B Repair Parts Selection Grid This web site has Aquastar 125B parts. It appears your unit was manufactured 7/7/02, so ...

bosch aquastar 125b My Bosch Aquastar 125B tankless water heater (serial no. 8 701 135 903) is not working properly. All connections are good, but when I try to light the pilot, there is an audible ...

is there any directions for installing Bosch Aquastar 125B Water Valve Assembly (conversion kit) - LOC 3365 - 8707002499 I would look on the Bosch wed site for this information .

...my Bosch aquastar 125B, and when I replaced it it is leaking from where it connects the system above it. Right where the set screws hold the valve . Any ideas? possible missing or bad gasket or o ...