Questions & Answers for: bobbin case not spinning

...Bobbin case spinning I'll try to describe this as well as I can. There is a black arm at the top of the bobbin case that has a spring attached to it and a little piece protruding that is supposed to ...

Bobbin Case Spins - in Huskystar C20 I broke a needle, so i took off the plate of my huskystar c20, took out the bobbin & then the bobbin case (to find the other half of the broken needle). Then put ...

...bobbin case to spin all the way around and then the needle hits the bobbin case. When the feed dogs are in the lowest position, the bobbin case does not spin all the way around when the needle moves ...

...bobbin case spinning When sewing, thread catches under the bobbin case and the whole case spins and pops up and the machine stops working (often breaking a needle in the process). Is there anything ...

...bobbin case The inside piece of my bobbin case is no longer stationary, it just spins freely. Is there a way to fix this or do I need to replace the entire bobbin case. replace the entire bobbin ...

...bobbin case catching on another part There is a small rod shape part pointing toward the bobbin case. The thread catches on this rod while sewing and causes the thread to tangle coming out of the ...

...bobbin case in, but when I put bobbin case and bobbin in machine it doesn't catch bobbin thread. Is this still timing Removed bottom of machine and fixed timing by adjusting wheel. when I spin needle ...

...fits on the bobbin winder. Also, when you install it in the bobbin case make sure it is only the thickness of the bobbin case. The wrong thickness will cause problems with it to spin or not

bobbin case but spins with a tilt, lower on the left and higher on the right. Bobbin touches plastic cover plate. Bobbin tilts and spins unevenly resulting in knotted threads bunching up on the bottom

...bobbin case spins but latch doesn't release the case. It's a Bernina 740. The bobbin is empty Use screwdriver to break open bobbin case. Use new bobbin case. Uh, I think I'd take it to a technician. ...