Questions & Answers for: blower motor works defrost 1983

AC is blowing but not coming out the vents My AC fan is blowing hard but it won't blow out of the vents. I can put the controller and the temp control on high and it blows out the defroster. When I ...

Ad

...are good I jumped wire at blower and blower is working Heater blower motor resister is bad, replace, located under dash above heater motor. check relay and blower resistor...likely the relay is

Ad

shorts in my 280z now it is not working my car has a spinning noise and that trys to start the car after i turn it off. jump-starting it used to work now it doesnt. Sounds like the starter is spinning

Question about 1983 280ZX

1 Answer

stalling my 1978 280z is hard to start,when it does start it will run for about five minutes or so,then it starts stuttering like its running out of gas and stalls and will not startup ,the fuel pump ...

1983 280z and he needs a new battery is there a exact type of battery i need for his car The best thing to do is go to Sears or an auto parts store and have them cross reference it. They will tell you

...blower motor series dropping resistor - this resistor module is usually located in the blower motor ducting in the air flow. 2) Faulty fan speed control switch, or poor connection in the associated ...

...Nissan told me today by phone to look under the dash on the passenger side, but this sounds crazy to me because the distrubutor is on the drivers side and in the front of the motor. Can anyone help ...

Question about 1983 Cherokee

1 Answer

...blower motor is ok It could be one of a couple of things. First, make sure all of the vacuum lines are good. The blower motor makes the air move, but its vacuum that sends it where you want it to go. ...

Nissan 280ZX 2.8L FI 6cyl www.autozone.com - its not searchable, but better than nothing. AutoZone will expect you to register (free) to access their repair database. Start with some of these - listed

Question about 1983 280ZX

1 Answer

...motor with hammer if you can reach it. Be VERY careful not to hit wires. If its real tight, I've done this with a crowbar tip from on top on different car. Point is to wack it while key is in ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...