Questions & Answers for: blower motor wont work high

...blower motor itself, or it could be an internal fault inside the motor. The blower motor should be on the passenger side floorboard underneath the dash. If you have the switch on high and smack the ...

blower motor to work on anything but high. I thought it might be the blower control switch in the dash console. I replaced that and it still only blows on high. Could it be the blower motor itself. Is

...blower motor my font blower motor quit so i replaced it and check all the fuses and it still wont work were is my problem? May be your resistor . Usually Up under dash (passenger side) near or at ...

blower motor wont work saturn sl2 blower motor wont work Disconnect connector at blower under pass side of dash.Check for power & ground with the blower switch in the #4 speed (High).Most Likely a

...blower motor and defrost i replaced what dealer said they were 99 percent sure it was a regulator or something under dash made no difference any suggestions to help please? IF THE BLOWER MOTOR ONLY ...

...on. Low barely blows and I hear the sound on med low, medium high and, sometimes high speeds. Should I replace the blower motor, motor wheel? Is it ok for an exceptional shadtree mechanic to

...blower motor quit running. Did you try it to see if it will run on any speed? If it won't run on high, but runs on the lower speeds, it is most likely a bad blower motor high relay. If it will not ...

...but not high There is a seperate blower motor relay for the high setting. check that first. It could be in the fuse box under the hood but i think it is near the blower motor... behind the glove

blower motor wont work good transformer and good capacitor Hello, bypass the board by jumping the L1 and high speed motor wire, if the blower works, bad board. If the blower does not work bad blower

...blower motor only wrks on low the blower motor only works on low, high wont work at all don't know if I should replace the blower motor resistor, blower motor or both It would be the resistor pack, ...