Questions & Answers for: blocked oil feed chainsaw

blocked chain oil feed tube on chain saw best way to unblock chain oil feed tube Drain out all the oil. You will have to have a air compressor or find some one who does. With a rag to help cover the ...

...feed enough oil. There is usually a screw on the bottom of the saw near the bar to adjust how fast the oil flows to the bar. When it's got enough oil, you should be able to spray a mist of oil onto a ...

...oil alert, if its been sitting it will have blocked jets. if its a briggs with a Quantum the bolt thats holds the caby bowl on has the main jet built in it. remove the bolt and clean the jet 2 holes ...

...both chain and bar overheat check that the part that turns the oil pump is in good condition, the oil pump gear isn't sticking and that the line from the pump to the bar isn't blocked cracked or ...

will not feed oil to the chain bar Sometimes the oil passages in the bar get pluged up and block the oil. Take the bar off the saw and clean out all the holes.

...oil inside cylinder head through sparky entrance screw spark plug back in try it now if it pops abit no matter after 5 times you have a carb prob float faulty jets blocked, blocked feed line, Advise ...

...Dumping oil out but not on the chain. Go on the Stihl web site download from there.as for the oil pump check the feed line to the bar make sure the feed pipe to make sure its not broken or

oil Is the pump blocked ? First remove your bar and check oil grooves and holes are clear, use a thin-bladed screwdriver or bar groove scraper. Clean your chain, and jet out the oiler bar-feed hole in

...blocked inside the oil tank. remove chain and bar and look at upper front corner where oiler is located the following links are the owner / operator manual the 2nd is the better STIHL 028 Chainsaw ...

...that small slot at the groove gets blocked with saw dust and stops the oil coming up to the chain when the chain cover is fitted that slot is blocked off forcing the oil up the slot onto the bar ...