Questions & Answers for: Nissan block seals

front brakes not getting fluid The brake lines are not blocked. I bled the lines clear. the master it must be bad take it appart check the piston out check the seal and O RING

...not. But I would check real close the OIL COOLER. Its the housing between the oil filter and the block. There is a seal (o ring) between that housing and the engine block and I would suspect that ...

...seals,cracked block or bad valves.If it smells a little like oil burning that could be rings or seals.If its a light colored smoke and no oil smell it could be a cracked head or block.My best ...

How do I put on a front crank seal? 1. Disconnect battery and block drive wheel. 2.Remove cooling fan and fan shroud 3.Remove drive belt 4.Remove front crank shaft sensor 5.Hold down the crank ...

...main seal(yeah,it's a pain).Gone are the days of using one of those "rope style" replacement seals(like on a small block Chevy) that you can slip in by just removing the pan(aint progress

can a blocked pcv cause a oil leak i have a blocked or faulty pcv can this cause enough pressure build up to force a oil leak at the crank seal The upper part of your engine is like a compressor. The ...

CAN CYLINDER LINERS WHICH ARE NOT SEALING PROPERLY TO THE BLOCK CAUSE PRESSURE IN THE COOLING SYSTEM? Hello Isaac, I doubt you pressure is caused by the liners. More likely you have a cracked head or ...

...reassemble water pump to the water pump body(or water pump cover or water pump housing ) to engine block. Not many people have a clue as to what the water pump COVER is... It is like the back 1/2 of ...

1987 Nissan civillian diesel 4cyl clutch slips when hot gears hard to change power gear changes ok leaks oil from bell housing drain hole when hot what could be wrong (clutch and pressure plate .? it ...

What is a slip code on a 2006 nissan titian truck mean it means there is a an intermittent code on one of the abs sensors. this can be the sensor is not reading the cog as its blocked. ie teeth on cog