blender's blades have jammed up. Even when there isn't anything in it, it won't spin anymore. The motor is running and everything else appears to be working okay. When the glass container isn't on top
Question about BPE3 Blender Express 2 Speed Blender
...blender blades is stuck on to the jar. My lid/blender blades is stuck on to the jar. Any suggestions on opening it. I have been trying to open it for 5 days. I have soaked it in hot water. Put it in ...
Question about K 750 CombiMax Food Processor
...blender blades which is cutting into the edges of the blender and stuck badly in the jar. Please help. Some bike locks go through the wheel and are about six inches long and are tempered. you can ...
Question about Mono Hand Blender - Black Single-Speed Handheld Blender
...blender,, if you only use one blade just rince the blade under the tap and dry it off before putting it away, the only way to un-screw the blade if its stuck is give it a sudden jolt on the side of ...
...blender is stuck together (glass and underneath part that would fit into motor base. Have a look at the pictures here. I think you are describing the blade unit's gasket being stuck. This can ...
...stuck under the blade, so I stired the contents. Then tried again and it only buzzed. Had to use my food precessor. I was afraid of burning the blender motor out. Smart move. The blade assembly is ...
The cup and blade are stuck in the machine? Any idea how to get it out? take it apart and so relieve the blade I have never had one and don't even know what one looks like, but almost certainly you ...
Question about Nutribullet Blender
How do I remove the nutribullet jar that is stuck to the blade housing? strip the housing to release the blade, it is the only way to go.
Question about Nutribullet Blender
blade shaft. If it seems to be stuck or jammed here check what is the causing it to be jamming. In most of the cases it is debris that are stuck in the blades of the blender that causes it to be stuck
check what is the causing it to become jammed . In most cases it is debris that are stuck in the blades of the blender that causes the jamming.Or it could be the fuse went bad and needs to be replaced
Usually answered in minutes!
71 Questions
68 Questions
53 Questions
57 Questions