...on the rear cylinders a couple of turns. Try to bleed the brakes enough to get them working and then drive to a place of repair. Otherwise remove the master cylinder, strip down and repair or
...bleed the brake same way . by this time the paddle should be getting hard not going to the floor. if it is recheck brake line work for leaks . if not game on after back is done recheck fluid move to ...
...1999 Isuzu Rodeo. Need advice on replacing the line before I start the job. its really easy your gonna need a line bender they are cheap about 10 to 15 dollars and some line and wrenches dont forget ...
how do you replace the slave cylinder Step 1 Raise the vehicle and support with jack stand placed underneath the frame. Step 2 Remove the cover from the reservoir on top of the clutch master cylinder.
...brakes,ie the peddle goes to the floor. after 2 pumps the pressure is back for initially 5km now only a couple 100 metres. i have bled the system 3 times, replaced the master cylinder and have no ...
...bleed breaks for a 99 isuzu rodeo v6 ls You'll need a helper to push on the brake pedal. Starting at the passenger rear open the bleeder screw and have your helper push down slowly on the brake ...
...suggest you still have air in the brake lines.. If you pump the brakes until you have pressure and the pedal feels spongy , then you still have air in the line somewhere. Bleed until air is
...if not the slave is leaking (bad) or both, master and slave are bad. this old a car. new parts bleed just like brakes do. using DOT 3 or ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions