...belt tight, you'll need to find the bolt holding the alternator, usually the top side of the unit. You will notice a curved opening where the bolt passes through, loosen the bolt and keeping the belt ...
belt between pulleys has 1/2 inch movement(too tight and your alternator will need new bearings very soon...)then do up the bolts,check belt tension after all bolts tight to confirm not to tight/loose
Question about 17.5 hp 42 in. Deck Lawn Tractor - CA Model
...belt will not get tight. the pully needs to be The belt will not get tight.I was told that the pully might need to be adjusted. How do you do this? It's for the v belt When looking at the belt system ...
belt tight ... thank you It'll be fine....the only thing would be to check it often. A tighter belt will often wear a little quicker than a properly fitting one.....by the way, you want a belt that is
...belt is tight like it was before you removed it. 7. Tighten the lock bolt. 8. Install the new alternator belt 9. Rotate the adjuster bolt clockwise until the belt is tight like it was before you ...
...BELT CANT BE TOO TIGHT WHERE WHEN YOU PRESS DOWN AT IT WONT GIVE IN NONE TOO TIGHT, WILL CAUSE PREMATURE ALTERNATOR BEARING FAILURE IF DRIVE BELT TOO TIGHT. IT'S PROBABLY THE BELT ...
...belt that turns power steering Belt is screaming and pulley is jamming in tight turns. Is belt to loose or too tight or is unit bad? Or what could be the problem? Its too tight. Loosen it a
...belt is to tight or not installed correct? verry possible the belt is to tight see if you can wiggle the belt at all if there is a little play then you need to check you pulleys on the motor if there ...
Question about 1996 Taurus
...belt wont tight ,idler pully is in good shape old belt came off thought it had streached it was almost new replaced it still having same problem. 3.0 4v dual overhead cam Are you sure the belt ...
Question about 1996 Taurus
...belt to tight and how do you know how tight to put the belt? The belt should be the same size as the old belt . It should only be tight enough to be able to move the treadle freely. It's a case of ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions