Question about 1997 Protege
...Belt Tensioner Tool, Or Wrench OR Ratchet, Rotate/Move the Tensioner USING THE AVAILABLE NUT (on the Pulley or Arm Base) OR the OPENING (3/8ths or 1/2 inch square opening) rotating the Tensioner ...
...cylinder, 2.3L with airconditioning There should be a belt tensioner which requires a socket and a ratchet to pull tension off the belt by prying on this tensioner in the opposite direction.. Good ...
...Belt Tensioner Tool, Or Wrench OR Ratchet, Rotate/Move the Tensioner USING THE AVAILABLE NUT (on the Pulley or Arm Base) OR the OPENING (3/8ths or 1/2 inch square opening) rotating the Tensioner ...
...belt tensioner arrow is within the proper adjustment range. Fig. 1: Often the underhood label will display the serpentine drive belt routing Fig. 2: Relieve the belt tension by pivoting the automatic ...
...belt tensioner was missing. No part there, but there never seemed to be a part on the boss for a tensioner pulley. Bolt threads were clean with no evidence of a bolt. Mechanic installed a short belt ...
...belt tensioner clockwise for 2001-2004 models and counterclockwise for 2005-2006 models. Remove the belt. To install, reverse the removal procedure. Serpentine Belt All Navajo and B Series Pick-up ...
...belt tensioner without the proper tool? TO LOOSEN THE BELT TENSIONER PULLEY ASSEMBLY, THEN POSITION A CAMSHAFT BELT ADJUSTER TOOL T74P-6254-A OR EQUIVALENT ON THE TENSION SPRING ROLL PIN AND RETRACT ...
BELT.IF YOU HAVE THE AUTOMATIC TENSIONER YOU NEED A BREAKER BAR PLACE IT IN THE TENSIONER .PUSH DOWNWARD FORWARD ON BREAKER BAR AND REMOVE THE DRIVE BELT. TO GET TO BELT TENSIONERS. YOU HAVE TO REMOVE
Fan belt diagram 1989BeltsINSPECTIONADJUSTINGREMOVAL & INSTALLATIONPrintINSPECTIONAll ModelsBelt tension is very important, as a belt that is too tight will put too much stress on the bearings of ...
Question about 2012 3 i Touring 4dr Hatchback 2.0L 4-cyl. 6-speed Manual w/SKYACTIV-G
...belt, the tensioner pulley is outside the belt pushing down on the belt. The easiest way to replace this belt, First remove the old belt by placing the socket on the mount point and pulling up on the ...
Usually answered in minutes!
738 Questions
692 Questions
544 Questions
609 Questions
615 Questions