Question about DC17 Animal Bagless Upright Cyclonic Vacuum
How to replace belt on Dyson DC17 How to change a Dyson DC17 belt Preface: Dyson folks were great, answer so simple I was embarassed after I called. 5 minute fix. 1. Loosen 3 screws from bottom plate ...
doesn't rotate roller is there a belt to replace? Yes, There is a belt on the DC07. If you have the DC07 with the clutch system you need this belt: ...
Question about DC07 Bagless Upright Cyclonic Vacuum
...but brush still doesn't rotate...makes a ratcheting noise. You probably need to change the belt. Even though the belt my look okay it can be stretched and therefore not turning the brush.
Question about DC07 Animal Bagless Upright Cyclonic Vacuum
Can the belt in the clutch be replaced or do I have to buy a new clutch and belt assembly? You don't need to replace the whole clutch, you can replace just the belt. You can get the clutch belt and ...
Question about DC07 Bagless Upright Cyclonic Vacuum
Seems like the belt may be getting old and not picking up as much as it used to. Belts need to be replaced periodically. If the belt is worn it will not pick up the way it should. You can get DC07 ...
Question about DC07 Bagless Upright Cyclonic Vacuum
the brush doesn't spin anymore, but the belt is not broken. model DC 07; approx three years old The belt may not be broken but after 3 years the belt will have stretched and it will not turn the brush
The brushes are not spinning. I get suction, but the brushes don't turn. Your belt has probably broken. Here is a link to the belt you need: Dyson DC17 Belt And here is instructions on how to change ...
belt not moving how do you check it The belt should be replaced yearly so if you haven't changed it recently, I would. You might find that the belt is still intact, but that doesn't necessarily mean ...
Brush is not moving brush is not moving...not sure if it's the belt...anyway to find out how the belt should be installed? Most likely it is the belt. Check to see if the belt is broken or the teeth ...
My dyson dc33 beater bar won't turn There are belts in the clutch, which is the lever you can move to adjust the vacuum from floor to tools. The belts become stretched and need to be replaced. You can
Usually answered in minutes!
1,132 Questions
870 Questions
836 Questions
655 Questions
597 Questions