Questions & Answers for: banging noise ford explorer put

...ford explorer I put my car into reverse, something went bang, like I had hit something, and then I had no reverse gear. Could this be the belt? If not please could you give me an idea. if your truck ...

...explorer in rev it didnt move and when it finally did it man a loud noise and jumped into gear. Do you know what the problem or solution is? Does the shifter work okey and was this a one time thing? ...

...Explorer 2WD will drive in forward gears but not reverse. I have changed the fluid, filter, & gasket but problem persists. There is a grinding noise when you put the vehicle in reverse only. your ...

...Explorer ford bangs into gear when warm My 2007 explorer goes into reverse hard when it warms up .The forward gears don't do it and the rest of the trany seems fine. It is a 4x4 4.0 lt with about ...

2004 ford explorer is making a banging noise when turning my 2004 ford explorer makes a loud banging noise when i turn, what would you say the problem is? check for loose track rod ends.

...banging noise while turning and the 4X4 high light flashes on and off as well as ABS light stays on One loud bang is usually a ball joint. Jack up one side of car and shake tire to see what is loose. ...

Delay on reverse It delays on reverse or sometimes it makes a bang noise Slipping tranny. Time for a rebuild or junkyard pick and pull

noise, no crunch, no engagement with the gear. if only the reverse is affected it will not be the converter,if you have no drive in any gears yes the converter drive splines may have stripped but when

banging, clicking and squealing sounds. These sounds often rear their heads or intensify whenever the driver takes ... Hissing or sizzling under the hood: Heard when the engine is first shut off, ....

...ford explorer a clunking noise when put in reverse. also some hesitation on changing gears stays high rpm during gear change. Check transmission fluid perhaps change the fluid and filter on ...